Turn-to-Close, Turn-to-Open 1/4 steel Fastener   Available in the following dimensions: 14mm, 17mm, 19mm.     Sold by unit, such as shown in the pictures. Decreasing prices : 3 € each 25 €  for 10 units 45 €  for 20 units

Pair of resistors for LED turn indicators. Sold by pairs. 1 pair of resistors is necessary for 1 pair of LED turn signals (USUALLY enough, although we cannot take responsibility if it is not : on some rare models you may need more than 1 resistor per blinker).  Power : 10W 10 ohm

Relax cruise control throttle grip for right side handlebar grip. Made in plastic, it will easily install directly on your throttle grip and will allow you to relax your wrist during long journeys. Universal model, will fit on nearly all accelerator grips.

Pair of resistors for LED turn indicators.   Sold by pairs. 1 pair of resistors is necessary for 1 pair of LED turn signals (USUALLY enough, although we cannot take responsibility if it is not : on some rare models you may need more than 1 resistor per blinker).   Power :  20 W 10 oHm 20 W 15 oHm

Tie down strap extension.   Measurements and technical information : LENGTH 1 : 50 cm LENGTH 2 (openned) : 1,0 m WIDTH : 2,5 cm   Sold by unit, such as shown in the pictures.

Turn-to-Close, Turn-to-Open 1/4 steel Fastener for allen key.   Available in the following dimensions: 14mm, 17mm.     Sold by unit, such as shown in the pictures. Decreasing prices : 3 € each 25 €  for 10 units 45 €  for 20 units

Frame cap kit universal.     Made of hard plastic Fits into the holes in the frame where the engine mounting screws are located Protects screws and bolts from moisture and corrosion Provides a neater finish Various diameters

Decorative anodised screw with colored offset.   INFO : M6 screw (6mm diameter) Screw length : 24 mm Length of the colour part : 20 mm Diameter of the colour part : 15.5 mm

Turn signals spacers adapters in plastic, specific for many YAMAHA and KAWASAKI. These adapters can also adapt on other models.   Will fit on all KAWASAKI models produced since 1990. Will also fit for YAMAHA produced before 2002. For example  R1 2000 - 2002 ; Fazer 1000 2001 - 2005 etc   In case of doubt, your OEM turn signals must be similar to those...

Motorcycle-design key ring, different models available.

Screw and cage nut in anodised aluminum. Sold per unit. Various colors available.

KAWASAKI  Keyrings - different models and designs available.

Decorative screw with anodised colored washer. M6x16mm

Windscreen fastening screws in anodised aluminum.   Sold individually (1 screw + washer + threaded rubber).   Caution : diameter 5 mm for this windscreen screw, on some Italian motorcycles you will need a diameter 4. Length : 15mm   Note: The design and head of the screws you will receive can be slightly...

Windscreen fastening screws in anodised aluminum.   Sold individually (1 screw + washer + threaded rubber).   Caution : diameter 5 mm for this windscreen screw, on some Italian motorcycles you will need a diameter 4. Length : 15mm   Note: The design and head of the screws you will receive can be slightly...